Anthem A2 | A/V Amplifier
Click on images to enlarge.
.
Description: 2 channels, RCA and XLR inputs, 225 continuous watts per channel into 8 ohms, 4-layer circuit board for low source impedance, Statement-level parts with hand-matched input stage devices, 2-ohm capability.
**********************************************************************************
Specifications:
GENERAL
• Inputs 2 Single-Ended, 2 Balanced, 1 Relay Trigger (3.5 mm Mono Jack)
• Outputs 2 Pairs Speaker Binding Posts, 1 Relay Trigger (3.5 mm Mono Jack)
• THD+N (200 W into 8 Ω) 0.001% at 1 kHz, 0.03% at 20 kHz
• IMD 0.0005% (CCIF, 225 W into 8 Ω)
• POWER BANDWIDTH 10 Hz to 100 kHz, (+0 -3 dB, 225 W into 8 Ω)
• FREQUENCY RESPONSE 20 Hz to 20 kHz (+0 -0.15 dB), 5 Hz to 100 kHz (+0 -2 dB)
• INPUT SENSITIVITY 1.5 Vrms in for 225 W out into 8 Ω
• INPUT IMPEDANCE 10 kΩ (RCA), 15 kΩ (XLR)
• DAMPING FACTOR 360 at 1 kHz (ref. 8 Ω)
• S/N RATIO 120 dB, A-weighted (ref. 225 W)
• CROSSTALK -78 dB at 1 kHz
• VOLTAGE GAIN 29 dB
• SLEW RATE 30 V/µs
SWITCHES
• Front Panel Power (On/Off)
• Rear Panel On/Off Modes (Trigger, Manual, Auto), Inputs (RCA, XLR)
DIMENSIONS
• Height 7-5/8 inches (19.4 cm) including feet
• Width Faceplate 19-1/4 inches (49 cm),
• Chassis 17-1/4 inches (43.8 cm)
• Depth 13-1/2 inches (34.3 cm)
• Weight (unpacked) 34 lb (15.5 kg)
**********************************************************************************
Warranty: Three years
Manufacturer: visit the Anthem Statement website here or see more Anthem Statement products here.
